Industrial production is slowly adopting manipulators to replace manual production labor. It has a wide range of applications in industrial enterprises. From assembly, testing, and handling to automatic welding, automatic spraying, and automatic stamping, there are corresponding robotic hands to replace manual labor and reduce staff In daily use, when encountering a failure, before or during the maintenance of the robot arm, the maintenance precautions of the robot must be followed to avoid danger. Non-standard robot

Non-standard robot

I. Precautions for robot maintenance:

1. Do not turn on the power or connect the air compressor to the manipulator, whether it is under repair or maintenance;

2. Do not use power tools in wet or rainy places, and keep good lighting in the work area;

3. During the adjustment or replacement of the mold, please pay attention to safety to avoid being injured by the manipulator;

4. Whether the robot arm rises / falls, introduces / retracts, crosses and unscrews the screws and nuts of each fixed part of the knife;

5. Whether the baffle for the adjustment of the up and down stroke and the introduction of the stroke, and the fixing screw of the fall arrester bracket are loose;

6, whether the trachea is twisted, whether there is air leakage in each trachea joint and trachea;

7. Except for proximity switches, defective suction clamps, and solenoid valves that can be repaired by themselves, others should be trained by professional personnel to perform repairs, otherwise do not change them without permission;

Second, the general list of robot maintenance tools

1. Hex wrench 2.5-8mm

2. Adjustable wrench 8-14mm

3. Cross screwdriver and slotted screwdriver

4. Pliers and Needle-nose Pliers

5. Three-use meter

6. Air spray gun

7. Oil gun