How to maintain after non-standard automated assembly

Everyone knows that no matter what equipment needs to be maintained in use, the following describes the annual maintenance of the non-standard automated assembly machine (the annual maintenance is to perform several times of maintenance every year). .

1. Check whether all electrical connectors in the electrical cabinet are loose.

2. Power on and check whether the power voltage of the equipment meets the requirements.

3． The inside and outside of the equipment are clean, free of dust and falling products.

4． Replace the reducer oil.

5. The transmission gears are greased.

6. Power-on test to check whether each operating mechanism works normally.

7. After maintenance, all joysticks should be placed in a non-working state, and the electrical control switches, knobs, etc. should return to the "0" position and cut off the power.

8. Fill out the annual equipment maintenance plan.